Dc governor accurate transfer and positive and negative point start detailed setting method
Positive &negative point move the implementation method of the switch quantity terminals (configuration) :
In dc governor SYSTEM (SYSTEM) menu find CONFIGURE the I/O (parameters configuration),

After entering will CONFIGURE ENABLE (configuration) by DISABLE to ENABLE menu, and then to the following operation:
1. In the menu CONFIGURE the I/O, find DIGITAL INPUTS (switch input), according to M button to enter, find DIGIN 1 (C6), will be the purpose of C6 mark (TAG) to take 228.

2. When C4 in high level is are turning, when C4 C6 and's at a high logic level is reversed. Are turning the reversal of the rate adjustment as follows: set PARAMETERS (SETUP PARAMETERS) menu find JOG/SLACK (the point start/relax), according to M, in this menu button to enter under JOG 1 and JOG find and SPEED, and SPEED, and he can change the dynamic of the positive and negative points, system for factory value rate plus or minus 5%.
Finally quit save parameters.
Parameters according to M key SAVE: DIAGNOSTS (or until after diagnosis), to press upward of key PARAMETER, the first find brings, and then press enter M up key head, parameters automatically SAVE. Press E key has been back exactly.

Positive &negative speed control realization method (the switch quantity terminal configuration) :
In dc governor SYSTEM (SYSTEM) menu find CONFIGURE the I/O (parameters configuration),

After entering will CONFIGURE ENABLE (configuration) by DISABLE to ENABLE menu, and then to the following operation:
1. In this menu (CONFIGURE the I/O) find INPUTS, in this menu ANALOG to produce stats ANIN found under 3 (A4), will be the purpose of the A4 TAG (TAG) to take 309 (it is 5).

2. In this menu (CONFIGURE the I/O) found in DIGITAL INPUTS, in this menu DIGITL found in 2 (C7), will it take the purpose of TAG) to mark (292 (from 118)

3, in this menu (CONFIGURE the I/O) found in the DIAGRAM, which in this menu find SPT SUM 1 DEST, its purpose mark to 5 (it is 289).

Finally the CONFIGURE ENABLE ENABLE then to DISABLE,

Finally quit save parameters.
Parameters according to M key SAVE: DIAGNOSTS (or until after diagnosis), to press upward of key PARAMETER, the first find brings, and then press enter M up key head, parameters automatically SAVE. Press E key has been back exactly.